Connect a Speco camera to VISEC.
Speco IP cameras support ONVIF. The usual pattern applies: give the camera a password, check the ONVIF service is enabled, and keep the stream on a standard codec.
Press scan.
VISEC searches your network for ONVIF cameras and lists what it finds. If your Speco camera already has ONVIF switched on, it appears here and you are watching live in a few seconds — nothing below is needed.
If the camera does not appear.
Menu names move around between firmware versions, so treat these as the place to look rather than an exact path.
-
Sign in to the camera
Open its address in a browser and sign in as the administrator.
-
Check ONVIF
Confirm the ONVIF service is enabled in the network or system settings.
-
Note the RTSP path as a fallback
If the scan will not find the camera, its manual gives the RTSP stream path, which can be entered directly.
-
Scan from VISEC
Press scan, pick the camera and sign in.
Once it is connected.
- Watch it liveOn its own or beside your other cameras, across up to 8 monitors.
- Record on motionChoose the part of the picture that matters and how sensitive it should be.
- Get an emailA snapshot the moment motion starts, so you know without watching.
- Read number platesPlate recognition is included in every license, including the free one camera license.
Try it on your Speco camera tonight.
The complete software, free for life on one camera. No card, no email, no trial clock.