Connect a Grandstream camera to VISEC.
Grandstream cameras support ONVIF and many models include physical input and output terminals, which makes them a practical choice where a camera needs to open a door as well as watch it.
Press scan.
VISEC searches your network for ONVIF cameras and lists what it finds. If your Grandstream camera already has ONVIF switched on, it appears here and you are watching live in a few seconds — nothing below is needed.
If the camera does not appear.
Menu names move around between firmware versions, so treat these as the place to look rather than an exact path.
-
Sign in to the camera
Open its address in a browser and sign in as the administrator. Set a strong password if it is a new camera.
-
Confirm ONVIF is enabled
Check the network or system settings for the ONVIF service and switch it on if it is off.
-
Choose the stream
Set the primary stream to the resolution you want recorded; keep a lighter secondary stream for remote viewing.
-
Scan from VISEC
Press scan, pick the camera and sign in.
-
Wire the outputs if you need them
Where the model has output terminals, connect them to the door strike, gate or relay and choose that action in VISEC.
Once it is connected.
- Watch it liveOn its own or beside your other cameras, across up to 8 monitors.
- Record on motionChoose the part of the picture that matters and how sensitive it should be.
- Get an emailA snapshot the moment motion starts, so you know without watching.
- Read number platesPlate recognition is included in every license, including the free one camera license.
Try it on your Grandstream camera tonight.
The complete software, free for life on one camera. No card, no email, no trial clock.